thermal dilatometer
英
美
网络 热膨胀仪
双语例句
- The sintering temperature and thermal expansion coefficient of the LSGM sample were determined using dilatometer.
用热膨胀仪确定了LSGM的烧结温度及热膨胀系数。 - The thermophysical and mechanical properties of SiCp/ Al composites were tested by thermal dilatometer, laser flash thermal conductivity apparatus and electronic mechanical testing instrument.
利用热膨胀仪、闪光导热仪、电子力学实验机等试验设备测试了SiCp/Al复合材料的热物理性能及基本力学性能； - The composites of different Mo/ Si ratio were prepared by vacuum liquid reactive sintering. The phase composition and microstructure of composites was analyzed by XRD and SEM, respectively. Their coefficients of thermal expansion ( CTE) were measured by thermal dilatometer.
利用液相反应烧结制备不同配比的Mo-Si复合材料，用X射线分析相组成，扫描电镜观察微观组织形貌，热膨胀仪测不同块体材料的热膨胀系数（CTE）。 - The computer control system of NSH full automatic thermal dilatometer
NSH型全自动热膨胀仪计算机测控系统 - This paper introduces the software, hardware and it's functions in NSH full automatic thermal dilatometer's computer control system.
介绍了NSH型全自动热膨胀仪计算机测控系统的软硬件构成及功能。 - Using powders prepared by high-gravity reactive precipitation ( HGRP), the characteristics of sintering kinetic curves of BaTiO_3 ceramics were studied in this work by means of a thermal dilatometer.
以超重力反应沉淀法（HGRP）制备的纳米钛酸钡粉体为原料，以热膨胀仪为测试手段，对钛酸钡陶瓷的烧结动力学曲线特征进行了研究。 - The micro-yield strength after different stabilized treatment and dimensional stability in thermal cycling conditions of SiCP/ 2024Al composites were measured by tension test and dilatometer.
利用万能拉伸试验机和热效应自动分析仪测试了SiCP/2024Al复合材料在不同稳定化工艺处理后的微屈服强度和热循环条件下的尺寸稳定性； - The thermal expansion behavior was examined by dilatometer ( DIL) and the damping capacity was evaluated by dynamic mechanical analysis ( DMA).
采用热膨胀仪（DIL）和动态机械分析仪（DMA）对材料的热膨胀性能和阻尼性能进行了测定。 - The thermal expansion coefficient ( TEC) of sintered ceramic sample was determined by dilatometer.
用热膨胀仪测定烧结样品的热膨胀系数。 - Thermal expansion behaviors of the composites were studied using a dilatometer. The relationship between thermal expansion coefficient and thermal mismatch stress was discussed.
利用热膨胀仪（DIL）测试该复合材料的热膨胀性能，对热膨胀系数与材料基体内热错配应力关系进行了探讨。 - At the same time the transformation points, Ac1, Accm and Ms were measured using thermal dilatometer and differential scanning calorimeter. Then different isothermal transformation treatments of the steels were carried out.
同时利用膨胀法和差示扫描量热法测定了两种钢的相变点Ac1、Accm和Ms。然后对试样进行了不同工艺的低温等温转变处理。